Table of Contents
Advertisement
2-7 Exhaust Deflector Plate
Installation Cont...
Figure 2-7b
Outer Engine
Mount Tube
Assembly
Figure 2-7c
Hair Pin
Clip
2-8 Top Assembly To Upper Frame
Assembly Installation
Align the pivot brackets of the top assembly P#(A0551)
to the pivot point on either side of the upper frame
assembly. Place (1) fender washer P#(K0041) between
pivot point (Figure 2-8a) and fasten by using (1)
P#(K1153) 5/16"-18 x 3/4" HHCS and (1) 5/16"-18 nyloc
nut P#(K1180). Repeat steps for other side. When
fastening leave nut slightly loose so that the top can
pivot freely. Refer to Figures 2-8a and 2-8b.
Upper Frame
Assembly
Figure 2-8b.
Clevis Pin
2-9 Deck Pulley Installation
Remove the grass deflector shield from the grass
dishcarge on the mowers deck. Remove the existing
spindle cover and hardware from the deck pulley. Figure
2-9a.
Stop unit, shut off deck attachment, set parking
brake, shut off mower engine and remove spark plug
wire before installing parts to the mower.
Do not work around the mower deck, PTO deck drive
or the blower area until you are certain that the
mower blades and the blower impeller have stopped
rotating.
8
Top Assembly
Figure 2-8a
Pivot Point
Top Assembly Here
!
WARNING
Upper Frame
Assembly
(1) 5/16"-18 x 3/4" HHCS
(1) 5/16"-18 Nyloc Nut
(1) Fender Washer
Per Side
Advertisement
Table of Contents
