Table of Contents
Advertisement
2-2 Lower Main Frame Leg Installation
Cont...
From the rear of the mower, align each lower main frame
leg, P#(B0528 Right) and P#(B0529 Left), to the lower
ROPS mounting holes and to the rear bumper slot holes.
Fasten to the lower ROPS mounting hole with existing
hex bolt and washer removed in section 2-3a. Fasten to
the rear bumper slotted hole by using (1) 1/2"-13 x 1"
HHCS P#(K1231), (1) 1/2" flat washers P#(K0055) and
(1) 1/2"-13 nyloc nut P#(K1247) per side. Refer to Figure
2-2b and 2-2c.
Figure 2-2b
Left Lower
Main Frame
Leg
Figure 2-2c
Left Lower Frame Leg
B0529
Attach to
Rear Bumper
Fasten Using Existing
Bolt and Washer
(1) 1/2" x 13 x 1" HHCS
(1) 1/2" Flat Washer
(Per Frame Leg)
Attach to R.O.P.S.
Right Lower Frame Leg
b0528
2-3 Outer Engine Mount Tube
Assembly Installation
Remove the lower 4 existing bolts from the rear heat
guard as shown in Figure 2-3a. Align the holes of the
outer engine mount tube assembly P#(A0605) to the
holes on the heat guard and fasten by using (4) 3/8"-16 x
1" Carriage bolts P#(K1182) and (4) 3/8"-16 Nyloc Nuts
P#(K1216). See Figure 2-3b.
Figure 2-3a
Remove Existing
Figure 2-3b
(4) 3/8"-16 x 1" Carriage Bolts
(4) 3/8"-16 Flange Nuts
2-4 Lower Mount Clamp Bracket
Installation
Mount the lower mount clamp bracket P#(B0302) to the
to the outer engine mounting tube using (1) 3/8" - 16 x
3.5" U-bolt P#(K0136) and (2) 3/8" - 16 nyloc nuts
P#(K1216). Place U-bolt on the outside of the outer
engine mount tube and place the mount clamp bracket
to the inside of the rear bumper of mower. Align holes in
bracket with U-bolt threaded ends and fasten with (2)
3/8"-16 nyloc nuts. See Figure 2-4a and 2-4b for
reference.
6
Rear Heat Guard
Hardware
Outer Engine
Mount Tube
Assembly
Advertisement
Table of Contents
