Operation Condition Monitor - Mitsubishi Electric G-50A Instruction Book

4 - 1 Operation condition monitor

• This function displays the ON/OFF/Malfunction status of specific units or group.
• ON/OFF/Malfunction status is shown by the indication corresponding to the unit or group appearing in inverse,
normal or blinking display.
• The user may select display items by unit address, group number or group name.
Refer to section "5-7 User setting (page 34)" for detail of user setting.
• During the user operation mode, this screen returns from any screen if there is no operation for approximately 10
minutes.
(1) Operation Method
• Note that operation is different for each of the following display methods.
<Unit address display>
<Group number display>
<Group name display>
(2) Display contents
1 Press the
eration and monitor.
2 When displaying the units in a given group, press the
all the units in that group ON or OFF.
1 Press the
number to be operated.
2 Press the
" " symbol to the on/off mode.
1 Press the
the group name to be operated.
2 Press the
" " symbol to the on/off mode.
Reverse: ON
*When a malfunction occurs, refer to section "4-4 Malfunction (page 23)".
GROUP switch to change the display group in desired op-
SELECT
ON/OFF
switch to set the displayed group unit is indicated by the
1
ON/OFF
switch to set the displayed group unit is indicated by the
1
*Displays up to the first 3 characters of the set group name.
Normal: OFF
OR
– 11 –
ON/OFF
1
switch to move the " " select the group
switch to move the " " symbol. Select
Blinking: Malfunction during
units is off.
Blinking and Reverse:
Malfunction during
unit is on.
switch turn