NHM-1
WCDMA RX Band Response Tuning
A signal generator is needed and test signal applied into NHM-1's connector.
•
Calibration is started from the Phoenix menu:
•
Press "Start" then "Tune".
•
The calibration routine will define the signal generator settings for you.
•
Set frequency and settings to defined values and allow the tuning to continue by
pressing "OK".
•
After this low and high frequency compensation values for RX band response will
be sored into PM when you press "Yes" to save changes.
Note: With the "Read" - button you can check the values stored in PM.
Page 76
Tunings/WCDMA/RX band response calibration
Copyright Nokia. All rights reserved.
CCS Technical Documentation
Issue 1 11/03