Setting Usb Parameters - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
DO Configuration
After connecting the 3G router to the SmartLogger properly, you can set DO configuration
parameters over the WebUI to make the external 3G router automatically reset if the
SmartLogger fails to connect to the NetEco, email server, or FTP server within 30 minutes.
On the Settings tab page, choose Port Settings > DO and set DO1, DO2, and DO3 to Reset
the external router or No control, as shown in
permission, select the User name as Advanced User.
Figure 7-68 DO configuration

7.28.2 Setting USB Parameters

This topic describes how to set USB parameters for resetting an external 3G router over the
WebUI.
Context
The SmartLogger provides a USB port, which has a power capacity of 5 V/1 A. If the DC
power cable of the 3G router has a standard USB connector and has a maximum current of
less than 1 A, it can directly connect to the USB port on the SmartLogger. Hence the
SmartLogger can power on or off the 3G router, which allows the SmartLogger to control the
reset of the 3G router when the communication link is interrupted.
Issue 04 (2013-12-15)
Set DO1, DO2, and DO3 to Reset the external router or No control based on the connections between
the router and the three DO ports of the SmartLogger.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 7-68. Because of the limited
7 Web User Interface
148