4.1.12
Stop/restart of cyclic transmission
Receiving data from other stations and sending data of its own station can be disabled in a case such as debugging.
(Transient transmission is not stopped.)
Each station's cyclic transmission can be stopped or restarted with a programming tool.
Note that this function is not available in circuit test mode.
CPU module
B0
Station No.1
Station No.2
Station No.3
Station No.4
(1) Operation procedure
1.
Open the "Link Start/Stop" window in the programming tool.
[Diagnostics]
2.
Operate the programming tool with reference to the following steps.
CC-Link IE Controller
CC-Link IE Controller
Network module
Network module
(Station No.1)
(Station No.2)
LB0
Station No.1
Station No.1
Station No.2
Station No.2
Station No.3
Station No.3
Station No.4
Station No.4
Stop/restart of
cyclic transmission
[CC IE Control Diagnostics]
CC-Link IE Controller
Network module
(Station No.3)
LB0
LB0
Station No.1
Station No.2
Station No.3
Station No.4
Cyclic transmission
Link refresh
button
CHAPTER 4 FUNCTIONS
CC-Link IE Controller
Network module
(Station No.4)
LB0
Station No.1
Station No.2
Station No.3
Station No.4
91
4