Applicable Systems - Mitsubishi Electric MELSEC Q Series Reference Manual

2.3

Applicable Systems

This section describes the applicable systems.
The number of mountable modules represents the maximum number of CC-Link IE Controller Network modules that
can be used together with MELSECNET/H modules.
(1) Applicable modules and base units, and No. of modules
(a) When mounted with a CPU module
For the CPU modules, the number of modules, and base units applicable to the CC-Link IE Controller Network
module, refer to the user's manual for the CPU module used.
Note the following when the CC-Link IE Controller Network module is mounted with a CPU module.
• Available functions differ depending on the serial number of the CPU module. (
3)
• For use with a High Performance model QCPU or Process CPU when total number of stations in a
network is 65 or more: Use a CC-Link IE Controller Network module whose serial No. (first five digits) is
09042 or later.
• Depending on the combination with other modules or the number of mounted modules, power supply
capacity may be insufficient. Pay attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of the modules.
• Mount a module within the number of I/O points for the CPU module. If the number of slots is within the
available range, the module can be mounted on any slot.
Remark
When the module is used with a C Controller module, refer to the user's manual for the C Controller module.
(b) Mounting to a MELSECNET/H remote I/O station
The CC-Link IE Controller Network module cannot be mounted to any MELSECNET/H remote I/O station.
Mount it to a CPU module on a master station.
(2) Support of the multiple CPU system
When using the CC-Link IE Controller Network module in the multiple CPU system, refer to the following first.
QCPU User's Manual (Multiple CPU System)
(a) Applicable CC-Link IE Controller Network module
The function version of the CC-Link IE Controller Network module has been "B" from the first release and it
supports the multiple CPU system.
(b) Network parameters
Network parameters must be set to the control CPU of the CC-Link IE Controller Network module.
40
Page 606, Appendix