Station No. Setting By Sequence Program - Mitsubishi Electric MELSEC Q Series Reference Manual

4.6

Station No. Setting by Sequence Program

For Universal model QCPUs, the station No. of a normal station (own station) can be set in the sequence program.
If there are any normal stations that can share the same sequence program and network parameters (except for
station No.), specifying their station numbers in the sequence program creates common project data for them, allowing
easy data management.
*1 Check the serial No. and software version for applicability. (
*2 For High Performance model QCPUs, station No. cannot be set in sequence programs.
Therefore, set it in Network parameters.
Programming tool
Station No. setting by
sequence program
136
For control
station
Common project data can be created for
For normal
stations
normal stations, resulting in easy management.
Station No. setting by
sequence program
For control For normal
station
Control
station
(No.1)
Normal
station
(No.6)
For normal For normal
stations
Station No. setting by
sequence program
Page 606, Appendix 3)
Station No. setting by
sequence program
For normal
stations stations
Normal
station
(No.2)
Normal
station
(No.5)
For normal
stations stations
Station No. setting by
sequence program
*1*2
Normal
station
(No.3)
Normal
station
(No.4)