Table of Contents
Advertisement
1. Jack-mount tube (tongue)
2. Jack
2.
Align holes in jack with holes in the mounting
tube and secure the jack with the clevis pin
(Figure
6).
4
Installing the Wire Harness
Parts needed for this procedure:
Wire harness assembly (topdresser harness,
1
controller harness, and tow-vehicle harness)
Procedure
1.
Plug the connector of the topdresser wire
harness into electrical connector on solenoid
valve of the machine
Figure 6
3.
(Figure
7).
g280872
1. Topdresser harness
2. Controller harness
2.
Route the ring terminals of the tow-vehicle
harness to battery of the traction unit.
3.
Assemble the ring terminal for the black wire of
the tow-vehicle harness to the negative battery
cable.
4.
Assemble the ring terminal for the red wire to
the positive battery cable.
5.
Unplug loop back connectors from each of the
harnesses and plug the topdresser harness,
controller harness, tow vehicle harness and
together.
Note:
To prevent dirt or corrosion to harness
connector pins, install the loop-back connectors
into electrical connectors whenever vehicle
harness is disconnected from the topdresser
harness.
6.
Route topdresser harness along tongue and
secure it to tongue with cable ties.
7.
Plug controller harness connector into
topdresser wire harness connector.
8.
Route to controller harness to the operator's
position in the traction unit and secure the
harness along frame rail with cable ties.
Note:
Wire harnesses have removable connectors
that allow you to permanently assemble the tow
vehicle harness to the traction unit and the topdresser
harness to the machine.
9
Figure 7
3. Tow-vehicle harness
g012647
Advertisement
Table of Contents
