Tensioning The Conveyor-Belt Chain - Toro Topdresser 2500 Operator's Manual

3. Rotate motor sprocket assembly
the wheel-drive chain deflects 3.2 mm (1/8 inch).
Note:
Access to chain is through cutout in lower
side of axle cradle.
Important:
Do not overtension the chain or it
will wear prematurely. Do not under-tension
the chain or it will cause sprocket wear.
4. Tighten mounting bolts.
Tensioning the
Conveyor-Belt Chain
1. Perform the steps in
(page 20).
2. Remove the chain cover
Figure 18
1. Chain cover
3. Loosen bolts and nuts that secure the motor and
sprocket assembly to the main frame
19).
4. Rotate motor and sprocket assembly
in mounting slots until the conveyer-belt chain
deflects 3.2 mm (1/8 inch).
Important:
Do not overtension the chain or it
will wear prematurely. Do not under-tension
the chain or it will cause sprocket wear.
(Figure 17) until
Preparing for Maintenance
(Figure 18).
(Figure
(Figure
1. Conveyer-belt chain
5. Tighten mounting bolts
6. Install chain cover
g012659
19)
22
Figure 19
2. Motor and sprocket
assembly
(Figure 19).
(Figure 18).
g012660