Table of Contents
Advertisement
– Do not leave the machine unattended while the
tow vehicle is running.
•
Ensure that the machine is connected to the tow
vehicle before loading.
•
Do not carry loads that exceed the load limits of
the machine or the tow vehicle.
•
The stability of loads can vary—for example, high
loads have a higher center of gravity. Reduce the
maximum load limits to ensure better stability, if
necessary.
•
To avoid causing the machine to tip over, do the
following:
– Carefully monitor the height and weight of the
load. Higher and heavier loads can increase
the risk of tipping.
– Distribute the load evenly, from front to back
and side to side.
– Be careful when turning and avoid unsafe
maneuvers.
– Always ensure that the machine is connected
to the vehicle before loading.
– Do not put large or heavy objects into the
hopper. This could damage the belt and rollers.
Also ensure that the load has a uniform texture.
The machine can unpredictably throw small
rocks in the sand.
•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Shut off the machine.
– Engage the parking brake.
– Shut off the engine and remove the key (if
equipped).
– Wait for all movement to stop.
•
Do not stand behind the machine when unloading.
•
Unload the topdresser or disconnect it from the
vehicle only while on a level surface.
•
Ensure that the machine is connected to the tow
vehicle before unloading.
•
Shut off the attachment when approaching
people, vehicles, vehicle crossings, or pedestrian
crossings.
•
When equipped, hydraulic trailer brakes may
overheat the fluid in the hydraulic circuit if the
brakes remain activated continuously. Always use
a lower speed gear selection when descending
long hills. Activate the brakes intermittently to
allow for cooling cycles for both the vehicle and
the topdresser.
Slope Safety
•
Review the vehicle specifications to ensure that
you do not exceed its slope capabilities.
•
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. The operator is responsible for
safe slope operation. Operating the machine on
any slope requires extra caution.
•
The operator must evaluate the site conditions
to determine if the slope is safe for machine
operation including surveying the site. Always
use common sense and good judgment when
performing this survey.
•
The operator must review the slope instructions
listed below for operating the machine on slopes.
Consider the operating conditions on that day to
determine whether to use the machine at the site.
Changes in the terrain can result in a change in
slope operation for the machine.
•
Avoid starting, stopping, or turning the machine on
slopes. Avoid making sudden changes in speed or
direction. Make turns slowly and gradually.
•
Do not operate a machine under any conditions
where traction, steering, or stability is in question.
•
Remove or mark obstructions such as ditches,
holes, ruts, bumps, rocks, or other hidden hazards.
Tall grass can hide obstructions. Uneven terrain
could overturn the machine.
•
Be aware that operating the machine on wet
grass, across slopes, or downhill may cause the
machine to lose traction. Loss of traction to the
drive wheels may result in sliding and a loss of
braking and steering.
•
Use extreme caution when operating the machine
near drop offs, ditches, embankments, water
hazards, or other hazards. The machine could
suddenly roll over if a wheel goes over the edge
or the edge caves in. Establish a safety area
between the machine and any hazard.
14
Advertisement
Table of Contents
