Setup; Installing The Tongue - Toro Topdresser 2500 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Certificate of Compliance
1

Installing the Tongue

Parts needed for this procedure:
1 Tongue assembly
4 Lynch pin
2 Clevis pin
Procedure
1. Insert the tongue through the front receiver tube,
the frame of the machine, and the rear receiver
tube (Figure 3).
Description
Tongue assembly
Lynch pin
Clevis pin
No parts required
Jack (optional)
Wire harness assembly (topdresser
harness, controller harness, and
tow-vehicle harness)
Skid
Carriage bolt
Flat washer
Locknut
Qty.
1
4
2
–
1
1
4
8
8
8
Qty.
1 View before operating the machine
1 CE Certification
1. Tongue
2. Align the holes in the tongue with the holes in
the receiver tubes, and secure the tongue to
the tubes with the 2 clevis pins and 4 lynch pins
(Figure
7
Use
Install the tongue.
Assemble the hitch to the traction-unit
drawbar.
Mount optional tongue jack.
Install wire harness.
Mount the skids.
Use
Figure 3
2. Front receiver tube
4).
g269253