Toro Topdresser 2500 Operator's Manual page 24

Removing the Conveyer Chain
1. Remove chain cover
Figure 23
1. Chain cover
2. Remove master link from chain and remove
chain from small sprocket
If needed, loosen the motor-mount bolts to
remove the master link.
Figure 24
1. Drive chain
2. Master link
(Figure 23).
(Figure 24).
3. Motor
Disassembling the Slider Bed
1. Loosen forward and rear jam nuts on tension
rod to release spring tension
1. Tension rods
g012659
2. At each side of machine, remove 2 capscrews, 2
washers, and 2 locknuts that secure the hopper
to slider-frame rails
1. Capscrews (hopper mounting)
3. Pivot hopper rearward and lean it against wall,
post, ladder, etc.
Important:
g012666
against the rear of machine to avoid
damaging the brush or the hydraulic
couplers.
Make sure that the hopper is pivoted beyond
center and/or secured to wall or post to
prevent it from accidentally falling on work
area (Figure
24
(Figure
Figure 25
2. Jam nut
(Figure 26).
Figure 26
Right side shown
(Figure 27).
Do not allow hopper to rest
27).
25).
g012667
g012668