Mitsubishi Electric MELSEC iQ-R Series User Manual page 60

Wiring products
The following describes the devices used for CC-Link IE TSN.
■Ethernet cable
Use Ethernet cable that meets the following standards.
Communication Ethernet cable
speed
1Gbps Category 5e or higher, straight cable (shielded, STP)
100Mbps Category 5 or higher, straight cable (shielded, STP)
Cables for CC-Link IE TSN are available from Mitsubishi Electric System & Service Co., Ltd. (Catalogs for cable are also
available.)
In addition, the connector processing of cable length is available for your preference. Please consult your local Mitsubishi
representative.
Communication Type
speed
1Gbps Category 5e or higher, straight cable (double shielded, STP)
A communication error may occur due to high-frequency noise from devices other than a programmable
controller in a given connection environment. The following describes countermeasures to be taken on the
RJ71GN11-T2 side to avoid high-frequency noise influence.
Wiring
• Use a duplex shield type cable.
• Do not bundle the cable with the main circuit or power cable or do not place it near those lines.
• Place the cable in a duct.
6 WIRING
58
Connector Type
RJ45 The following conditioning cables:
connector • IEEE 802.3 (1000BASE-T)
• ANSI/TIA/EIA-568-B (Category 5e)
The following conditioning cables:
• IEEE 802.3 (100BASE-TX)
• ANSI/TIA/EIA-568-B (Category 5)
Model (Manufacturer)
SC-E5EW series (Mitsubishi Electric System & Service Co., Ltd.)