Table of Contents
Advertisement
Operation
Press the large button above the handle to turn
the product on and off.
Power floor head assembly
Assembly:
To use the product in floor cleaning mode, join the 2 sections of the extension tube and fit the
power floor head at the end. Ensure all parts are correctly lined up and push them into place.
Ensure the product is switched off before removing or fitting attachments.
To disassemble, place your fingers in the indents of the tube, grip and pull the sections apart.
6
Max
Eco
The product has 2 power settings: Max mode
(higher suction power and shorter runtime) and
Eco mode (lower suction power and longer
runtime). Change modes by sliding the switch
located in front of the On/Off button. The
product will turn on in the mode it was last
used.
Disassembly:
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Pro2 and is the answer not in the manual?
Questions and answers
The m/c runs for about a min. then stops when put on charge the green lights go on and off
The Gtech Pro 2 may stop running after about a minute due to a low battery. The flashing green lights indicate that the battery is charging. Recharge the battery fully (which takes 4 hours) before using the vacuum again. If the issue persists, check for blockages or other obstructions.
This answer is automatically generated