Table of Contents
Advertisement
Bag installation
Remove the lid by pulling gently upwards.
New bags have a tendency to sit flat when first
attached. Pull the bag down to sit vertically.
Fit the bag collar onto the tube underneath
the lid and push it up firmly.
To get maximum efficiency from the bag, it is
important to expand the bag before insertion.
Do not use the vacuum without a bag: it
may damage the motor and will invalidate
your warranty.
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Pro2 and is the answer not in the manual?
Questions and answers
The m/c runs for about a min. then stops when put on charge the green lights go on and off
The Gtech Pro 2 may stop running after about a minute due to a low battery. The flashing green lights indicate that the battery is charging. Recharge the battery fully (which takes 4 hours) before using the vacuum again. If the issue persists, check for blockages or other obstructions.
This answer is automatically generated