Table of Contents
Advertisement
Optional extras
Power brush
To attach the power brush, slot it over the
standard nozzle. The power must be off while
changing nozzles. The power button will now
power the brush as well as the suction.
To clean the brush bar, first remove the power
brush. Rotate the latch from the 'lock' to the
'unlock' position and pull out the brush bar.
14
To remove the power brush, press the buttons
on the sides of the attachment and pull it away
from the main unit.
To remove hair from the brush bar, run the hair
removal tool down the groove to cut the hair,
then pull it out. Never operate the power head
without the brush bar in.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Pro2 and is the answer not in the manual?
Questions and answers
The m/c runs for about a min. then stops when put on charge the green lights go on and off
The Gtech Pro 2 may stop running after about a minute due to a low battery. The flashing green lights indicate that the battery is charging. Recharge the battery fully (which takes 4 hours) before using the vacuum again. If the issue persists, check for blockages or other obstructions.
This answer is automatically generated