Do you have a question about the Pro2 and is the answer not in the manual?
Questions and answers
john edward pinnington
February 26, 2025
The m/c runs for about a min. then stops when put on charge the green lights go on and off
1 comments:
Mr. Anderson
February 26, 2025
The Gtech Pro 2 may stop running after about a minute due to a low battery. The flashing green lights indicate that the battery is charging. Recharge the battery fully (which takes 4 hours) before using the vacuum again. If the issue persists, check for blockages or other obstructions.
• Store indoors in a dry place out of the reach • Only use batteries and chargers supplied by of children. Gtech. • Always use responsibly. This appliance • Never modify the charger in any way. can only be used by children aged from 8 •...
• Do not use the appliance if any part is not clean in a dish washer. damaged or defective. • Only use authentic Gtech bags, • Repairs should be carried out by a service batteries, charger etc. agent or a suitably qualified person in •...
Thank you for choosing Gtech “I started Gtech to create sensible, easy to use products that do a great job. Your opinion is important to us and we’ll use your feedback to improve our products and services, and to let other people know what it’s like to be part of the Gtech family.”...
Operation Press the large button above the handle to turn The product has 2 power settings: Max mode the product on and off. (higher suction power and shorter runtime) and Eco mode (lower suction power and longer runtime). Change modes by sliding the switch located in front of the On/Off button.
Page 7
Place your foot gently on the A forward motion will pick up Pulling the vacuum back head of the vacuum and pull larger pieces of debris. towards you activates the the body back towards you. AirLOC and picks up You will hear a click. finer particles.
Above the floor cleaning LED headlight For above the floor cleaning, you can fit the There is a headlight on top of the product to crevice tool or dusting brush for reachable areas illuminate the area being cleaned. or fit the extension tube with an accessory for high up cleaning State of charge 100% - 75%...
Battery charging When a single green light flashes, recharge Plug the charger in and connect it to the the battery. charging port on the side of the battery. hour hours boost After 4 hours, all 4 LEDs will show solid green You can also charge the product for 1 hour for and charging is complete.
To replace the battery, slot it into the front of Push the battery into the slot until it clicks into the product from the bottom first, with the place. If you want to buy a spare battery, go to latch facing outwards. www.gtech.co.uk or call 08081 685 028.
Bag installation Remove the lid by pulling gently upwards. Fit the bag collar onto the tube underneath the lid and push it up firmly. New bags have a tendency to sit flat when first To get maximum efficiency from the bag, it is attached.
Dispose of the bag and replace with a new one. Carefully remove the bag from the product lid (You can get more bags at www.gtech.co.uk or to avoid squashing contents. Insert the bag by calling 08081 685 028).
Page 13
If the suction is low when the bag is empty and a new bag is fitted you may have a blockage Remove the battery and lid and look through Remove the bag from the lid. the nozzle. Remove any blockages. Check for any blockages in the lid.
Optional extras Power brush To attach the power brush, slot it over the To remove the power brush, press the buttons standard nozzle. The power must be off while on the sides of the attachment and pull it away changing nozzles. The power button will now from the main unit.
Page 15
If your original cartridge no longer smells, it can still be used. If you’d like new scented cartridges, go to www.gtech.co.uk or call 08081 685 028. Flexible power hose The flexible power hose attaches in the same way as the other accessories and can be used as it...
Page 16
Optional extras Car Accessory Kit The three tools from the Car Accessory Kit fit directly into the nozzle of the product.
Optional extras Wall mount 1072mm The tools can be stored like this on the wall Install your wall mount at least 1072mm from mount. Your wall mount will look like the the floor. Universal fixings have been included picture on the right when fully assembled with - please use the correct fixings for the wall type the product.
If these initial tips do not solve your problem, we have various other ways to help. Visit: www.gtech.co.uk/support Online Live chat support support@gtech.co.uk How to videos GTECH PRO 2 TECHNICAL SPECIFICATION Battery model 109A0015 Battery 22V 2000mAh Li-Ion Charging period...
Page 21
If you purchased directly from Gtech, your details are already registered and your 2-year warranty will start automatically. If you purchased from an authorised Gtech retailer, please register your warranty within 3 months. You will need to provide proof of purchase to support any claim against your warranty.
symbol indicates that this product is Call your local council, civic amenity site or recycling covered by legislation for waste electrical and centre for information on the disposal and recycling of electrical products. Alternatively, visit electronic products (EN2002/96/EC) www.recycle- for advice on recycling and to find your more.co.uk When the vacuum has reached the end of its life, it and nearest recycling facilities.
Need help?
Do you have a question about the Pro2 and is the answer not in the manual?
Questions and answers
The m/c runs for about a min. then stops when put on charge the green lights go on and off
The Gtech Pro 2 may stop running after about a minute due to a low battery. The flashing green lights indicate that the battery is charging. Recharge the battery fully (which takes 4 hours) before using the vacuum again. If the issue persists, check for blockages or other obstructions.
This answer is automatically generated