Mitsubishi Electric GOT1000 Series User Manual page 22

(2) Precautions for laying cable
(a) Coaxial cables must be laid 100mm or more apart from power
cables and control cables.
(b) Consider wiring using double-shielded coaxial cable in places
that are subject to large amounts of noise.
Double shielded coaxial cable
Mitsubishi Cable ... 5C-2V-CCY
Grounding
The 5C-2V connector plug is applicable to double-shielded
coaxial cable.
Connect the 5C-2V connector plug to the coaxial cable inside a
double-shielded coaxial cable. Ground the shielded part outside
a double-shielded coaxial cable as shown in the above figure.
(3) Double shielded caoxial cables have the following restrictions on the
bending radius.
Allowable bending radius
Cable type
3C-2V
5C-2V
(4) Do not pull any of the connected coaxial cables.
This will cause a faulty contact, cable disconnection, or damage to
the unit.
(5) Make sure to connect a terminal resistor to both terminal stations of
the coaxial bus type network system.
(6) The F type connector has the possibility to extract a white oxide
according to the use enviroment.
However, there is no problem on the function because the oxide is
not generated in connected part.
Enlarged view
of cable
Internal
conducter
r [mm](in.)
23 (0.91)
30 (1.18)
13
Sheath
Insulation External
material conductor
Connector
A[mm](in.)
50 (1.97)
Sheath
External
conductor
(Grounding)
A
r