Yamaha RM1x Owner's Manual page 90

12. Job
2. Source segment
The upper "M" values set the phrase segment from
which data are copied.
Settings: Measure: beat:clock
001:1:000 ... 257:1:000
3. Start point of destination segment
The lower "M" value set the start point for the copy on
the destination phrase.
Settings: Measure: beat:clock
001:1:000 ... 257:4:479
4. Times
This multiplier specifies the number of times the seg-
ment is copied.
Settings : 01 ... 99
Job 12 Erase Event
1
3
This job clears all data from the specified segment of the des-
ignated style, so that the segment becomes silent.
1. Phrase setting: Phrs
Sets the phrase from which data are to be cleared.
Settings : 001 ... 256
2. Segment (M001:1:000 ~ M257: 1:000)
Sets the area of the phrase to be cleared.
Settings : Measure: beat : clock
001:1:000 ... 999:8:479
3. Event
Sets the event type to be cleared (at the center of the
screen).
Settings : Note Note events
PC
PB
CC
CAT
PAT
EXC
ALL
90
RM1x SEQUENCE REMIXER
2
Program change
Pitch bend
Control change (Any single
control-change message type
000 to 127, or all control-
change messages)
Channel aftertouch
Polyphonic aftertouch
System exclusive
All events
Job 13 Extract Event
1
3
4
This job moves all instances of specified event data from a
selected segment of a phrase to the same segment on a differ-
ent phrase. Following the operation, the targeted events no
longer exist in the source segment.
If data already exist at the destination side, the extracted data
and existing data are mixed.
1. Source phrase
The upper Phrs setting selects the phrase from which
events are to be extracted.
Settings : 001 ... 256
2. Source segment (M001:1:000~M257:1:000)
Select the phrase segment for the extraction.
Settings : Measure: beat : clock
001:1:000 ... 257:1:000
3. Destination phrase
The lower Phrs setting selects the destination phrase.
Settings : 001 ... 256
4. Event
Select the event type to be extracted (at the center of
the screen).
Settings : Note Note events
PC Program change
PB Pitch bend
CC Control change (Any single
control-change message type
000 to 127, or all control-
change messages)
CAT Channel aftertouch
PAT Polyphonic aftertouch
EXC System exclusive
2