Job - Yamaha RM1x Owner's Manual

3. Job

3. Job
You use the RM1x's pattern chain jobs to perform various operations on phrases and patterns.
You select the job from the job menu using the Display Knob 1, 2 or the CURSOR buttons. You can also make your selection
using the F4 button.
Note that the job menu is too large to fit entirely on the screen. But you can scroll through the list using the Display Knob 1, 2
or the CURSOR buttons.
Job List
Category
UNDO/REDO 00 Undo/Redo
EVENT 01 Copy Event
EVENT 02 Erase Event
MEASURE 03 Create Measure
MEASURE 04 Delete Measure
CONVERT 05 Convert to Song
CHAIN 06 Copy Chain
CHAIN 07 Clear Chain
CHAIN 08 Chain Name
Parameter
Category
Job
Select
To Select a Job
Same as in the PATTERN mode. Refer to page 81.
CAUTION !
Do not turn off the power while a job is executing (while the "Executing..." message is on the screen), as this may cause
destruction of your recorded data.
112
RM1x SEQUENCE REMIXER
Values
If UNDO: Cancel the last operation. If REDO: Cancel the last UNDO
Copy all events in specified segment to designated destination.
Erase all events over selected segment (and replaces with rests).
Insert empty measures into all tracks.
Delete specified measures from all tracks.
Converts the Pattern Chain data to Song data and places the results in the
normal song tracks after converting the data to standard MIDI format.
Copy data from selected pattern chain into destination pattern chain.
Delete all data from selected pattern chain.
Assign a name to the selected pattern chain.
Values
UNDO/REDO, EVENT,
MEASURE, CONVERT, CHAIN
00 ... 08
Function
Function
Selects the category.
Selects the job.
Jumps to the job currently selected in the job list.
See page
113
113
113
113
113
114
114
114
114