Yamaha RM1x Owner's Manual page 41

• Variation = System
When Variation connection is set to System, the three ef-
fects will be connected as shown in the diagram below.
volume expression
part 1 PAN
volume expression
part 2 PAN
volume expression
part 3
PAN
volume expression
part 16 PAN
(pages 69, 120)
The signals from all tone generator parts will be sent to
the reverb effect, chorus effect, and variation effect ac-
cording to the Voice submode settings Reverb Send Level
(pages 64, 120), Chorus Send Level (pages 64, 120), and
Variation Send Level (pages 64, 120). Here you can adjust
the effect depth for each part.
The stereo location of the effect output is determined by
the Effect submode settings Reverb Pan (pages 72, 121),
Chorus Pan (pages 71, 121), and Variation Pan (pages 70,
121).
dry level
rev send
cho send
var send
dry level
rev send
cho send
var send
dry level
rev send
cho send
var send
dry level
rev send
cho send
var send
DRY LINE
thick line indicates a stereo signal
REVERB
PAN
reverb
pan
send chorus to reverb
CHORUS
PAN
chorus
pan
send variation to chorus
send variation to reverb
VARIATION
PAN
variation
pan
(pages 64, 120)
If Variation connection = System, three bus lines will be
connected. Send Chorus To Reverb (pages 71, 121) is a
bus line that connects the Chorus Effect to the Reverb Ef-
fect. Send Variation To Chorus (pages 70, 121) is a bus
line that connects the Variation Effect to the Chorus Ef-
fect. Send Variation To Reverb (pages 70, 121) is a bus
line that connects the Variation Effect to the Reverb Ef-
fect. By using these three bus lines, you can use the effects
in a variety of ways, such as connecting the three effects
in series, or dividing them.
6. Effect block
reverb
return
OUTPUT
chorus
return
variation
return
41
RM1x SEQUENCE REMIXER