Samsung OfficeServ 7100 Technical Manual page 77

Table of Contents
Home Page
OfficeServ 7100 INSTALLATION
TECHNICAL MANUAL PART 8 APRIL 2007
iDCS 18 Button Line Key Default
Note: Other types of iDCS, DS and ITP phones can be connected however the line keys
will have a different default button configuration.
One the OfficeServ 7100 system is booted, the MP10 card verifies the cards mounted
on each slot and saves this information as the default configuration of the system. At
default, the OfficeServ 7100 system assigns 3 digits to Co lines, extensions, and
extension groups. Refer to Sections 3. Installing and Replacing cards of this manual
for details on switch 2.
CO line numbers from 701 through 7XX are sequentially assigned (by default) to the
first CO line card installed in the system from left to right and following numbers are
continuously assigned to the next CO line card of the next slot.
Extension numbers from 201 through 2XX are sequentially assigned to the first station
type card mounted in the system from left to right (starting from 4DLM if mounted on
the MP10) and following numbers are continuously assigned to the next extension card
of the next slot. This numbering process continues until the extension numbers are
assigned to all extensions.
8.4