e
Non Master/Slave Mode
f
Routing Network Cables Routing Network Cables
NOTE
Use a straight-through
cable to directly connect
two subracks.
Use a crossover cable or
a straight-through cable to
directly connect a subrack
to the NMS computer.
Connect network cables to
the AUX board.
STAT
PROG
AUX
STAT
PROG
AUX
STAT
PROG
AUX
STAT
PROG
AUX
Route network cables.
STAT
PROG
AUX
NMS computer
STAT
PROG
AUX
STAT
PROG
AUX
STAT
PROG
AUX
`
33
Network cable
NM_ETH1
NM_ETH2
ETH1
ETH2
STAT
PROG
AUX
CAUTION
Connect RJ-45 cables according
to the picture and do not connect
RJ-45 cables to the LAMP
interfaces.
NOTE
Connect the NE with the SC1\SC2
board to the NMS computer.
Cable tie
Diagonal pliers
Bundle the network cables (if there is
no outside fiber winding direction, just
bundle cables in the inside one).
AUX