Troubleshooting - Blomberg DV 17540 NBL00 Owner's Manual & Installation Instructions

7

Troubleshooting

Problem Cause
Drying process Lint filter may not have been
takes too long. cleaned.
* It may not plugged in.
Dryer does not * The loading door may be ajar.
switch on or the * Program may not be set or the
program does not
start. Dryer does not have been pressed.
not start when set.
Program is
* The loading door may be ajar.
interrupted for no
* Electricity may be cut off.
reason.
Laundry has
shrunk, become * A program not suitable for the
felted or has laundry type might have been used.
deteriorated.
* The 2-hour anti creasing program
to prevent laundry from wrinkling
LED flashes.
may have been activated.
* Program has come to an end.
LED is on.
* Lint filter may not have been
LED flashes. cleaned.
* A heat sensor failure has occurred.
dryer ends the program without
flashes.
heating.
Call an authorized service if the problem persists.
Explanation / Solution
* Clean the lint filter.
* Meshes of the filter may be
* Make sure that the dryer is
plugged in.
* Make sure the loading door is
properly closed.
* Make sure the program has been
* Deactivate the childproof lock.
* Make sure the loading door is
properly closed.
button to start the program.
* Dry only the laundry which is
suitable for drying in the dryer. First
check the labels on the clothes.
* Select a program a suitable low
temperature setting for the laundry
type to dry the clothes.
* Turn off the dryer and take the
laundry out of the dryer.
* Turn off the dryerand take the
laundry out of the dryer.
* Clean the lint filter.
* Meshes of the filter may be
* Turn off the dryer and remove the
laundry. Call the authorized service.
043