Toro ProCore Operator's Manual page 43

Chopper to Brush Belt
To adjust or reinstall the belt, proceed as follows:
1. Remove the belt cover (Figure 60).
Figure 60
1. Chopper to brush belt
cover
2. Idler pulley
2. Loosen the nut on the idler pulley (Figure 60).
3. Slide the belt off the chopper shaft and brush pulley
(Figure 60).
4. Rotate the brush pulley until a brush row is aligned
with the rotating corner (Figure 61).
Figure 61
1. Brush row
2. Rotating corner
5. Rotate the chopper until a blade tip is aligned with
the outside of the brush housing (Figure 61).
3. Nut
4. Chopper to brush belt
3. Blade tip
4. Brush housing
6. Carefully slide the belt onto the chopper shaft. Do
not rotate the chopper shaft.
7. While tensioning the right side of the belt, slide the
bottom of the belt into the grooves of the brush
pulley. Do not rotate the brush pulley.
8. While pushing the idler pulley into the belt, tighten
the nut on the idler pulley.
Brush to Rotating Corner Belt
To tension the belt proceed as follows:
1. Remove the belt cover (Figure 62)
2. Loosen the nut on the idler pulley (Figure 62).
1. Brush to rotating corner
belt cover
2. Brush to rotating corner
belt
3. Push the idler pulley into the belt and tighten the
idler pulley nut Figure 62).
4. Install the belt cover.
43
Figure 62
3. Idler pulley
4. Nut