Disconnecting The Core Processor From The Tow Vehicle - Toro ProCore Operator's Manual

1. Storage pin
2. Front hole (Core processor
disconnected from tow
vehicle)
Important: When changing tow vehicles or
tractors, make sure the hydraulic fluids are
compatible with the core processors. If the fluids
are not compatible, any fluid remaining in the core
processor must be removed.
6
Disconnecting the Core
Processor from the Tow
Vehicle
No Parts Required
Procedure
1. Remove the storage pins from the rear hole position
(Figure 16).
2. Slowly lower the processor until it comes to rest on
the rear roller and tires. Install the storage pins into
the front hole position (Figure 16).
3. After the storage pins are installed, turn off the tow
vehicle.
Figure 15
3. Rear hole (Core processor
connected to tow vehicle)
1. Storage pin
2. Front hole (Core processor
disconnected from tow
vehicle)
4. Lower the jack to the ground to stabilize the machine
(Figure 17).
1. Jack
5. Move the hydraulic lift lever back and forth to
remove pressure from hydraulic lines.
6. Disconnect the hydraulic hoses from the tractor.
7. Remove the remote control from the vehicle.
8. Wind the hoses and cable onto the harness mount
for storage.
9. Remove the lynch pin and hitch pins securing the
pitch control link. Remove pitch control link.
Note: The aerator may have to be slightly raised
to remove the hitch pins.
10. Remove the lynch pin and hitch pins securing the
tow-arms to the aerator.
Note: The aerator may have to be slightly raised
to remove the hitch pins.
16
Figure 16
3. Rear hole (Core processor
connected to tow vehicle)
Figure 17