3
Mount the Jack Stand
Parts needed for this procedure:
1
Jack stand
1
Jack stand tube
Procedure
Remove the bolt and nut securing the tow bar to the
front of the core processor (Figure 7). Remove the tow
bar.
1. Tow bar
2. Bolt
1. One Pass Operation
2. Insert the jack stand tube into the tow bar mounting
hole (Figure 8).
Figure 7
3. Nut
1. Tow bar mounting hole
2. Bolt
3. Jack stand tube
3. Rotate the tube until the holes line up with the holes
in the core processor.
4. Using the bolt and nut previously removed, secure
the tube to the core processor (Figure 8).
5. Slide the jack stand onto the jack tube, align the
mounting holes and secure with the lynch pin
(Figure 8 & Figure 9).
13
Figure 8
4. Jack stand
5. Nut
Figure 9