Mounting The Core Processor To The Workman Vehicle - Toro ProCore Operator's Manual

7
Mounting the Core Processor
to the Workman Vehicle
Parts needed for this procedure:
1 Hitch pin (included with the tow hitch)
1 Lynch pin (included with the tow hitch)
12 Cable tie
Procedure
The core processor must be equipped with the Tow
Hitch Kit, Model No. 09750 before it can be mounted
to the vehicle.
1. Back the vehicle into position in front of the core
processor. Make sure the processor brush is set for
correct height of cut.
2. Adjust the processor hitch tongue to the same level
as the vehicle hitch (Figure 18). The core processor
frame should be level with the ground when it is on
the rear roller.
3. Connect processor hitch to vehicle hitch with a hitch
pin and lynch pin (Figure 18).
Figure 18
1. Processor hitch
2. Tow vehicle hitch
4. Raise the jack and secure it in the storage position
(Figure 19).
3. Lynch pin
4. Hitch pin
1. Jack
5. Connect the hydraulic hoses to the vehicle quick
couplers. Make sure the hydraulic hoses are properly
connected to the processor and the vehicle.
6. Route the control harness over the bed of the vehicle
to the operators position.
Important: Make sure the hoses and control
harness are not kinked and that they bend freely
during operation.
7. Remove the storage pins from the front hole
position and insert into the rear hole position during
operation (Figure 20).
1. Storage pin
2. Front hole (Core processor
disconnected from tow
vehicle)
8. To extend the tow hitch proceed as follows:
• Make sure the latch handle pin is in the unlocked
(rear) position (Figure 21).
17
Figure 19
Figure 20
3. Rear hole (Core processor
connected to tow vehicle)