AUTO
Purpose
The AUTO is used to create line numbers automatically
in the line edit mode at the time of program writing.
Form
AUTO [<line number>[,[<increment>]]]
Description
(1) V/hen <line number> specification is made, the
system displays the specified line number and waits for
the key-in of a statement.
V/hen the statement is keyed
in and <CR> is pressed, the system displays a new line
number, which is the current line number plus the
increment and waits for another statement to be
entered.
The same process is repeated.
(2) V/hen the line number specification is omitted, the
creation of line numbers starts from 10.
specification of <increment> is omitted, 10 is assumed.
(The line numbers go 10, 20, 30 and so on.)
V/hen the
(3) V/hen the line number is specified as <line number>,
only the previous increment (if one has been used) is
designated.
(-4) The AUTO mode is stopped by pressing the <BREAK>
key and the control returns to the Sanyo-Basic Mode.
When the line number exceeds 65535 or when a line edit
error is found in the keyed-in statement, the system
displays an error message and returns the control to
the Sanyo-Basic Mode .
3-36