HP 9000 300 Series Hardware Configuration Manual page 98

3. The address jumpers are the three in the middle. There are two pins to the
left and one pin and an empty space to the right. The address jumpers
have the values shown in Figure 6-5.
Address
4
2
0
X
2
X
3 X
X
4 X
--- --- ---
4
2 1
5 X X
6 X X
Figure 6-5. Setting the Address Jumpers
4. Move the jumpers to obtain the desired address.
Note Do not change the setting of the other two positions. Removing
the jumper from the first position will result in no parity
checking, and installing a jumper in the second position will
result in a non-functional drive.
5. Write the Device Address here: _________ _
6. SCSI circuits must be terminated properly. The new drive must be
terminated unless there is an external SCSI connector on the rear panel.
Configuring Mass Storage Devices 6-19
6