HP 9000 300 Series Hardware Configuration Manual page 66

Example Existing Memory vs. Upgraded Memory
Total RAM PAIR 0 RAM PAIR 1
Existing 8 MB 4 MB 4 MB
Upgraded
3. Add up the new RAM board sizes to the existing RAM board sizes and
write the total in Table 5-2's 'Upgraded-Total' block. In this example,
adding 16 Mbytes to 8 Mbytes equals 24 Mbytes. You would write in '24
MB' as shown below:
Example Existing Memory vs. Upgraded Memory
Total RAM PAIR 0
RAM PAIR 1
Existing 8 MB 4MB4MB
Upgraded 24MB
4. In Table 5-2, you would fill in the upgraded board configurations as follows:
a. RAM PAIR 0 would have the largest size board pair, or an 8 Mbyte board
in each slot totaling 16 Mbytes.
b. RAM PAIR 1 slots would have an existing 4 Mbyte board reinstalled in
each slot; the original 8 Mbytes.
5. You would remove the existing 4 Mbyte boards from 'RAM PAIR 0 and
install them in RAM PAIR 1 slots.
Memory Configurations 5-17
5