HP 9000 300 Series Hardware Configuration Manual page 34

3
Possible Function and Meaning
Response
CD0®
Selects the respective internal interface to configure.
CDC[)
®
Stores all the listed new values you entered in the EEPROM.
You can turn OFF your controller, then turn it back ON and
the new values will be used. Then the self-test will run.
@)
Exits the Configuration Mode and stores the factory default
values in the EEPROM. You must cycle controller power to
reconfigure the interfaces to these default values.
®
Causes the Boot ROM to reset and run the power-up self-test
without saving any changes you may have made to the interface
values. The pre-existing values will be used.
Enter your response followed by
[Return)
after the? prompt.
If you decide to use the default configurations, exit the menu by pressing
@)
followed by
[Return ).
4
Select the interface to
reconfigure by pressing the key
for that interface.
For example, to select SCSI,
press:
®
Configurable Interfaces
Keys Interface Select Code
1 LA.
2 HP-IB
3
SCSI
4 HP Parallel
5
RS-232
• store le9 values
21
14
12
9
D store Default values
(then cycle SPU p0ger)
A Abort 9ithout changes
Type [key] RETURI ?
3-4 Configuring Internal Interfaces and Boot Modes