HP 9000 300 Series Hardware Configuration Manual page 93

6
CD ROM Disk Drive
Preliminary Requirements
Before you start to reconfigure your CD ROM drive, refer to Chapter 3 and 4
to
1. Shut down your controller's application program and operating system.
2. Turn OFF your controller and unplug all cords and cables from it and any
attached expanders.
3. Access the controller's internal assemblies.
Setting the Configuration Jumpers
Figure 6-4 shows you the configuration jumper locations. Jumpers and their
settings are explained in Table 6-4. Note the jumper positions that represent
an 'out' and 'in.'
Figure 6-4. CD ROM Configuration Jumper Locations
6-14 Configuring Mass Storage Devices