Westerm D20C: Jumpers - GE D20 Installation And Operation Manual

GE Energy
Connections and Configuration
WESTERM Jumper locations on the WESTERM D20C:
D20C: Jumpers
Z1
JPs Z17 & Z18
Z17 & Z18
To set Module address jumpering on Z1, see "WESTERM Addressing", page 65.
Use jumpers:
•
Z2 and Z3 for supply voltage setting
•
Z19 and Z20 for contact wetting configuration
•
Others to set Trip/Close, Raise/Lower and Control Outputs
See table below, next page.
General
Full
, continued
Z9 to Z16
Z2, Z3 & Z4
994-0078-2.00-7
D20/D200
Installation and Operations Guide
Z19 & Z20
71