Wesdac Board Jumpers; Wesdac Jumpers Z1-Z5; Checking The Base Version - GE D20 Installation And Operation Manual

GE Energy
Connections and Configuration
WESDAC There are five jumpers on the WESDAC A, S, K and C boards, located in similar
Board Jumpers positions on each of the boards:
Notes: The WESDAC D20A board is shown as an example.
WESDAC Jumpers Z1 to Z5 are used to set the Base software compatibility on the WESDAC
Jumpers Z1-Z5 boards.
Check what Base the D20/D200 main board is using and set the jumpers
accordingly. There are two possible settings:
•
For Base 3.11 or older
•
For any other base.
Note:
Checking the Use the following table to determine which Base version you have. Inspect the
Base Version BootROM labels on D20M, D20M+ and D20M++ main boards.
General
Full
, continued
Jumpers Z1 to Z5 Jumpers Z1 to Z5
The WESDAC D20AC board has no jumpers.
If you are replacing a WESDAC peripheral board, you will not see these
jumpers on older versions of the board.
BootROM labels on BASE 3.11 or older boards
D20M & D20M+ Boards
0.41X
1.01
2.00
2.01
3.00
3.01 (SBD004/00)
3.02 (SBD003/00)
3.03 (SBD005/00)
3.03A (SBD000/00)
Installation and Operations Guide
D20M++ Boards
3.02 (SBD006/00)
3.03 (SBD007/00)
3.03A (SBD008/00)
994-0078-2.00-7
D20/D200
63