Warning Sticker; Cabinet Installed Units (Ip00, Ul Type Open) - ABB ACS800 Series Hardware Manual

Wire size
kcmil/AWG Manufacturer
4 Burndy
2 Burndy
1 Burndy
Thomas & Betts 54148
1/0 Burndy
Thomas & Betts 54109
2/0 Burndy
Thomas & Betts 54110
11.Tighten the clamping nuts of the cable glands.
After connecting the control cables, fasten the clear plastic shroud and front covers.

Warning sticker

There are warning stickers in different languages inside the packing box of the drive.
Attach a warning sticker in the language of your choice onto the plastic skeleton
above the power cable terminals.

Cabinet installed units (IP00, UL type open)

The drive can be installed in a cabinet without the plastic front, top and connection
box covers and without the lead-through plate.
It is recommended:
• to ground the cable shield 360 degrees at the cabinet entry. Grounding with the
360 degrees grounding clamps at the connection box back plate is then not
needed.
• to lead the cable unstripped as close to the terminals as possible. Ground the
twisted shields of the power cables under the PE and grounding clamps.
Secure the cables mechanically.
Protect the RMIO board terminals X25 to X27 against contact when input voltage
exceeds 50 VAC.
Cover the power cable terminals with the clear plastic shroud as shown in section
Power cable installation procedure
Cabinet duct plates can also be used, see section
(optional) on page 43.
Compression lug
Type
YA4C-L4BOX
Ilsco CCL-4-38
YA2C-L4BOX
Ilsco CRC-2
Ilsco CCL-2-38
YA1C-L4BOX
Ilsco CRA-1-38
Ilsco CCL-1-38
YA25-L4BOX
Ilsco CRB-0
Ilsco CCL-1/0-38
YAL26T38
Ilsco CRA-2/0
Ilsco CCL-2/0-38
on page 73.
Crimping tool
Manufacturer Type
Burndy MY29-3
Ilsco MT-25
Burndy MY29-3
Ilsco IDT-12
Ilsco MT-25
Burndy MY29-3
Ilsco IDT-12
Ilsco MT-25
Thomas & Betts TBM-8
Burndy MY29-3
Ilsco IDT-12
Ilsco MT-25
Thomas & Betts TBM-8
Burndy MY29-3
Ilsco IDT-12
Ilsco MT-25
Thomas & Betts TBM-8
Installing cabinet duct plates
77
No. of crimps
1
1
2
1
1
2
1
1
3
2
1
1
3
2
1
1
3
Electrical installation