Disassembly Procedure Of Main Parts; Removing Base Unit; Removing Rotation Unit - Sanyo VCC-9300 Mechanism Service Technical Information

DISASSEMBLY PROCEDURE OF MAIN PARTS

1. Removing Base unit

1-1. Lift up on Stopper 19 from Base unit, then snap it to stop.
1-2. Turn Main unit counterclockwise 10 degree to remove Base unit from Main unit.
1-3. Remove Sefety wire ass'y 154 from Base unit.
1-3-1. Push Sefety wire ass'y 154 slightly while holding its end, then release it from locking.
1-3-2. Move Sefety wire ass'y 154 along with the groove.
1-3-3. Remove Sefety wire ass'y 154 from the hole of groove.
19
Stopper
1
2

2. Removing Rotation unit

Turn Clear dome 28 counterclockwise 13 degree to remove.
2-1.
2-2. Remove Screws 101 (x4) from the inside of Case 1 , then remove Rotation unit.
Safey wire ass'y
Figure of Step 1-1 through Step 1-3
28
Clear dome
Figure of Steps 2-1 and 2-2
–9–
Base unit
154
Main unit
1
3
2
101
Screws
3x10 mm (x4)
1 Case
Rotation unit
101