Table of Contents
Advertisement
12. Arranging Harness
12-1. Add Power/ Main cable ass'y 156 to the unit reassembled in Step 11-2, and make every connection of the connectors.
Then shape Harness by Binder 63 .
Note1: Refer to the following for arranging Harness. (The portions indicated by circles are the cables banded
together.)
Note2: Make sure to arrange the cables without touching the inside of Case 1 when turning.
156
Power/ Main cable ass'y
203
CN303
2P connector
for Camera cable
B
A
C
Power board ass'y
156
2P connector
for Slip ring
*Make sure of the cable direction
(Black, Gray, Red)
Figure of Step 12-1 and Note1
B
3P connector
for Tilt motor
201
Main board ass'y
Power/ Main cable ass'y
–33–
The unit reassembled in Step 11-2
C
D
Figure of Step 12-1
A
CN102
1
D
3P connector
for Pan motor
5P connector
for Slip ring
9P connector
for Camera
cable
Advertisement
Table of Contents
