Network Management Card (Optional); Installing A Serial Network Management Card (Optional) - ABB PowerValue 11/31 T Operating Manual

6.2 USB port
The UPS can communicate with an USB-compliant computers. To establish communication between
the UPS and a computer, connect the USB cable that comes with the UPS to the USB port on the
UPS. Connect the other end of the USB cable to the USB port on a computer. The USB port is
compliant with USB 1.1 protocol.

6.3 Network Management Card (Optional)

PowerValue 11/31 T is equipped with two intelligent slots for optional cards for remote management of
the UPS through internet / intranet. The accessories below can be installed in any of the intelligent slots.
SNMP Card - SNMP, HTTP and monitoring capabilities through a Web browser interface.
AS400 Card - AS400 card for AS400 communication protocol.
6.3.1

Installing a Serial Network Management Card (optional)

Each UPS has a communication slot for an optional Serial Network Management (SNMP) Card. After
installing an SNMP card, an environmental monitoring probe can be connected to the UPS.
THE UPS DOES NOT HAVE TO BE SHUTDOWN BEFORE INSTALLING A
COMMUNICATION CARD.
NOTE!
To install the Network Management Card, go through the following steps:
1. Remove the two screws that protect the communication slot of the UPS.
2. Insert the SNMP card into the communication slot.
3. Screw the SNMP card onto the slot using the screws removed in step 1.
Compatible SNMP card: CS141 Basic, CS141 ModBus, CS141 Advanced, WinPower
For more information on the SNMP Cards, see the SNMP User's Manual. For more details about
parameters available when using SNMP card with PowerValue 11/31 T, please refer to Appendix A and
B.
Modifications reserved
Page 40/49