Ups Storage; Planning Before The Installation - ABB PowerValue 11/31 T Operating Manual

Examine the UPS for any sign of damage and ensure that the received UPS corresponds to the material
indicated in the delivery note. Notify your carrier or supplier immediately if damage is apparent. The
content of the package is:
- 1 x PowerValue 11/31 T UPS
- 1 x User manual
- 1 x parallel cable
- 1 x parallel port cover plate
- 1 x Metal 3 pin connector
- 1 x Metal 2 pin connector
- 1 x Cable for connections from M2 to L3
- 4 x cable glands
- 1 x Monitoring Software CD
4.1.3

UPS storage

If you plan to store the UPS prior to use, keep the UPS in a dry, clean and cool storage room with an
ambient temperature between -15 °C and +60°C and humidity of less than 95% non-condensing. If the
packing container has been removed, protect the UPS from dust. Keep the UPS always in upright
position and do not drop the equipment.
4.1.4

Planning before the installation

The appropriate place of installation for the unit is to be selected in such a way that the danger of
damage to the UPS is minimized and a long service life of the device is thus ensured. Please observe
the following instructions:
- Install the UPS in an indoor area.
- Leave 50 cm of space on each side of the cabinet to enable cooling airflow and ensure that the
circulation of air to the ventilation slits is not obstructed.
- Avoid excessively high temperature and excessive moisture.
- Make sure that the surface is solid and flat.
- Note that water condensing may occur if the UPS is unpacked in a very low temperature
environment.
In this case, it is necessary to wait until the UPS is fully dried inside out before proceeding with the
installation to avoid hazards and electric shock.
Modifications reserved
Page 17/49