Toro Reelmaster 3100-D Edge Series Installation Instructions Manual page 7

Note:
The shoulder bolt should not clamp the
plate to the housing.
8. Check to ensure that the roller-brush plate is
parallel to the cutting-unit side plate. If it is not
parallel, proceed as follows:
A. Loosen the 2 flange locknuts securing
the roller-brush mounting bracket to the
cutting-unit side plate
B. Rotate the roller-brush bearing housing until
the brush plate is parallel to the cutting-unit
side plate (Figure
C. Tighten the 2 flange locknuts securing
the roller-brush mounting bracket to the
cutting-unit side plate
1. Loosen these bolts for positioning the roller brush.
2. Loosen these nuts for making the roller-brush plate parallel.
Positioning the Roller Brush
1. Loosen the 2 bolts securing each roller-brush
bearing housing to the roller-brush mounting
bracket (Figure 13).
Note:
The bolts should be loose from the
factory.
2. Position the roller brush so that it is just touching
or resting on the rear roller
Important:
The roller-brush shaft must not
contact the cutting-unit sideplate.
Important:
Heavy brush contact on the
roller will cause premature brush wear.
(Figure 13).
13).
(Figure 13).
Figure 13
(Figure 14).
1. Bearing housing (some
parts not shown)
2. Sideplate
3. Roller brush
4. Ensure that there is
clearance here.
Note:
The roller-brush shaft must be parallel
to the rear roller.
g193249
Important:
bearing housings so that they are parallel
to the ground to ensure clearance for the
rear-roller grease fitting.
3. Tighten the 2 bolts securing each roller-brush
bearing housing to the roller-brush mounting
brackets.
Installing the Drive Pulley
1. Insert the spacer onto the shaft in the bearing
housing (Figure
2. Insert the drive pulley into the spacer and onto
the driveshaft
Note:
Ensure that the pulley tabs are positioned
in the slot in the driveshaft.
3. Secure the pulley and spacer to the driveshaft
with a flange-head bolt (3/8 x 2 inches); refer
to Figure
Note:
Torque the bolt to 47 to 54 N∙m (35 to
40 ft-lb).
7
Figure 14
5. Light contact
6. Rear roller
7. Grease fitting
Position both roller-brush
15).
(Figure 15).
15.
g027303