Toro Reelmaster 3100-D Edge Series Installation Instructions Manual page 4

Mounting the Roller-Brush
Housing
1. Ensure that the O-ring is installed on the
roller-brush housing
1. Roller-brush housing
2. Mount the roller-brush housing to the
reel-bearing housing with 2 hex-socket bolts (3/8
x 1 inch); refer to
Note:
Position the roller-brush housing so that
the threaded hole is toward the front of the
cutting unit.
Note:
Ensure that the O-ring is properly
positioned in the roller-brush housing.
1. Roller-brush housing
2. Hex-socket bolt
(Figure 4).
Figure 4
2. O-ring
Figure 5.
Figure 5
3. Threaded hole
Repositioning the Idler Pulley
Assembly (For Right-Hand Drives
Only)
Note:
Right-hand drives are on Reelmaster 3100
Cutting Unit 3 (Figure
Units 2 and 4 (Figure
For right-hand rear roller brush drives
Figure 2), reverse the idler pulley assembly to mount
on the right end of the cutting unit
follows:
1. Remove the idler pulley assembly from the left
end of the cutting unit and mount it to the lower
hole in the brush plate on the right end of the
cutting unit
g009051
Note:
The idler pulley must pivot freely; do not
overtighten the locknut on the idler pivot bolt.
2. Remove the carriage bolt and nut and relocate
them to the upper hole previously occupied by
the idler pulley assembly
1. Idler pulley installation for
g218674 left end of reel (as supplied
in kit)
2. Idler pulley installation for
right end of reel
Removing the Brush Cover Drain
Plug
Remove only the bottom drain plug
the brush covers. This allows moisture to drain from
the belt area.
4
1) and Reelmaster 7000 Cutting
2).
(Figure 1
(Figure
(Figure 6).
(Figure 6).
Figure 6
3. Carriage bolt and nut
4. Do not overtighten this
locknut.
(Figure
and
6) as
g029307
7) from