Toro Reelmaster 3100-D Edge Series Installation Instructions Manual page 2

Media and Additional Parts
Description
Operator's Manual
Note:
Determine the left and right sides of the cutting
unit from behind the cutting unit.
Important:
The Rear Roller Brush Kit is only to be
used when cutting in the height of cut range of 6 to
25 mm (1/4 to 1 inch). Use the High Height of Cut
Brush, Part No.115-0838 (for 27 inch cutting units)
and Part No. 115-0849 (for 32 inch cutting units)
when cutting above 2.5 to 5.1 cm (1 to 2 inches).
Refer to Installing the High Height of Cut Brush.
Note:
If you are going to install both a universal
groomer kit and a rear roller brush kit on the cutting
unit, order the appropriate rear roller brush kit (Model
03242) for use with a universal groomer kit.
Rear Roller Brush Kit Model 03243 may be used
on the following:
•
Reelmaster 3100 Cutting Unit Models 03188,
03189, and 03190
•
Reelmaster 7000 Cutting Unit Models 03721 and
03722
Rear Roller Brush Kit Model 03246 may be used
on the following:
•
Reelmaster 3100 Cutting Unit Model 03191
•
Reelmaster 7000 Cutting Unit Model 03727
Qty.
1 Read before installing and operating.
1
Determining the Orientation
of the Roller Brushes
No Parts Required
Procedure
Use Figure 1
brushes and reel motors for a Reelmaster 3100-D
machine and
machine.
1. #1 cutting unit
2. #2 cutting unit
3. #3 cutting unit
2
Use
to determine the position of the roller
Figure 2 for a Reelmaster 7000-D
Figure 1
Reelmaster 3100-D
4. Left roller brush drive
assembly
5. Reel motor
6. Right roller brush drive
assembly
g029306