Pre-Maintenance Procedures; Pre-Maintenance Safety - Toro Groundsmaster 7210 Series Operator's Manual

CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Pre-Maintenance
Procedures
Important:
The fasteners on the covers of this
machine are designed to remain on the cover
after removal. Loosen all of the fasteners on
each cover a few turns so that the cover is loose
but still attached, then go back and loosen them
until the cover comes free. This will prevent you
from accidentally stripping the bolts free of the
retainers.

Pre-Maintenance Safety

•
Before adjusting, cleaning, repairing, or leaving
the machine, do the following:
– Park the machine on a level surface.
– Move the throttle switch to the low-idle position.
– Disengage the cutting units.
– Lower the cutting units.
– Ensure that the traction is in neutral.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
Figure 57
Service Interval Chart
– Allow machine components to cool before
performing maintenance.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Use jack stands to support the machine or
components when required.
•
Carefully release pressure from components with
stored energy.
43
decal125-2747