Driving The Machine - Toro Groundsmaster 7210 Series Operator's Manual

Hide thumbs Also See for Groundsmaster 7210 Series:
Table of Contents

Advertisement

you start the engine for the first time. Operate the
lift lever and PTO lever to ensure that they operate
properly. Shut the engine off, check fluid levels,
and check for oil leaks, loose parts, and any other
noticeable malfunctions.
Note:
Leave the throttle midway between the S
and F
positions until the engine and hydraulic
AST
system warm up.
Shutting Off the Engine
CAUTION
Children or bystanders may be injured if they
attempt to move or operate the tractor while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
Figure 24

Driving the Machine

The throttle control regulates the engine speed as
measured in rpm (revolutions per minute). Place
the throttle control in the F
performance. Always operate in the F
position when running powered attachments.
CAUTION
The machine can turn very rapidly. You may
lose control of it and cause personal injury or
g191793
damage the machine.
• Use caution when making turns.
• Slow the machine down before making
LOW
sharp turns.
1. Release the parking brake.
Note:
motion-control levers out of the N
position with the parking brake engaged.
2. Move the levers to the center, unlocked position.
3. Drive the machine as follows:
To move straight forward, slowly push the
motion-control levers forward
To move straight rearward, slowly pull the
motion-control levers rearward
To turn, slow the machine by pulling back on
both levers and then push forward on the
lever on the opposite side from which you
want to turn
To stop, pull the motion-control levers to the
N
EUTRAL
25
Figure 25
position for best
AST
The engine shuts off if you move the
(Figure
26).
position.
g191795
throttle
AST
-
EUTRAL
LOCK
(Figure
26).
(Figure
26).

Advertisement

Table of Contents
loading

Table of Contents