Adjusting The Height Of Cut - Toro Groundsmaster 7210 Series Operator's Manual

Engaging the Power Takeoff (PTO)
The power-takeoff (PTO) switch starts and stops the
mower blades and some powered attachments.
Note:
If the engine is cold, allow the engine to warm
up 5 to 10 minutes before engaging the PTO.
Figure 28
Disengaging the PTO
Figure 29

Adjusting the Height of Cut

You can adjust the height of cut from 2.5 to 15.8 cm
(1 to 6 inches) in 6 mm (1/4 inch) increments by
relocating the stop pin into different hole locations.
1. With the engine running, push the deck-lift
switch up until the mower deck is fully raised and
release the switch immediately
2. Rotate the stop pin until the roll pin in it lines up
with the slots in the holes in the height-of-cut
bracket and remove it
3. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, insert
the pin, and rotate it down to lock it in place
(Figure 30).
Note:
There are 4 rows of hole positions
(Figure 30). The top row gives you the height of
cut listed above the pin. The second row down
gives you the height listed plus 6 mm (1/4 inch).
The third row down gives you the height listed
plus 12 mm (1/2 inch). The bottom row gives you
the height listed plus 18 mm (3/4 inch). For the
15.8 cm (6 inch) position, there is only 1 hole,
g032826
G009174
g009174
(Figure 27).
(Figure 30).
located in the second row. This does not add
6 mm (1/4 inch) to the 15.8 cm (6 inch) position.
1
2
1. Stop pin
4. Adjust the anti-scalp rollers and skids as
required.
27
Figure 30
2. Height-of-cut stop
G020870
g020870