Serial Port Transmit Pace Setup; Hardware Configuration Query - HP ESA-E Series Programmer's Manual

Card two uses port numbers 3 and 4
Card three uses port numbers 5 and 6
Card four uses port numbers 7 and 8
Factory Preset
(no *RST): The factory default is none. This parameter is
persistent, which means that it retains the setting
previously selected, even through a power cycle.
Front Panel
Access:
none

Serial Port Transmit Pace Setup

:SYSTem:COMMunicate:SERial[1]|2|3|4|5|6|7|8:TRANsmit:PACE
XON|NONE
:SYSTem:COMMunicate:SERial[1]|2|3|4|5|6|7|8:TRANsmit:PACE?
Set the transmit pace to on or none for an instrument, with the RS-232
interface installed. If no optional serial port number is specified, port 1
is assumed.
There can potentially be four I/O cards installed (1, 2, 3, or 4). Each
card may have up to two ports:
Card one uses port numbers 1 and 2
Card two uses port numbers 3 and 4
Card three uses port numbers 5 and 6
Card four uses port numbers 7 and 8
Factory Preset
(no *RST): The factory default is none. This parameter is
persistent, which means that it retains the setting
previously selected, even through a power cycle.
Front Panel
Access:
none
Hardware Configuration Query
:SYSTem:CONFigure:HARDware?
Returns string of information about the current hardware in the
instrument.
Front Panel
Access:
System, Show Hardware
Chapter 5
Language Reference
SYSTem Subsystem
5-119