Sense:obwidth Subsection - HP ESA-E Series Programmer's Manual

SENSe:OBWidth Subsection

Set OBW Number of Averages
[:SENSe]:OBWidth:AVERage:COUNt <integer>
Set the occupied bandwidth measurement number of averages.
Remarks: This command is used for measurements in the
MEASURE
Front Panel
Access:
none
OBW Averaging On/Off
[:SENSe]:OBWidth:AVERage[:STATe] OFF|ON|0|1
Turn on or off occupied bandwidth averaging.
Factory Preset
and *RST: Off
Remarks: This command is used for measurements in the
MEASURE
Front Panel
Access:
Meas Setup, Avg Number On Off
Set OBW Span
[:SENSe]:OBWidth:FREQuency:SPAN <freq>
Set the occupied bandwidth span. The analyzer span will retain this
value throughout the measurement.
Remarks: This command is used for measurements in the
MEASURE
Front Panel
Access:
Meas Setup, OBW Span
Set OBW % Power
[:SENSe]:OBWidth:FREQuency:SPAN <freq>
Set the occupied bandwidth power in percent.
Remarks: This command is used for measurements in the
MEASURE
Front Panel
Access:
Meas Setup, Occ BW % Pwr
Chapter 5
menu.
menu.
menu.
menu.
Language Reference
SENSe Subsystem
5-93