En - R6; Obey The Safety Instructions; Check If Capacitors Need To Be Reformed - ABB ACQ580-01 Quick Installation And Start-Up Manual

EN – R6...R9 Quick installation guide
This guide briefly describes how to install the drive for IEC use. For complete
information on installation, see ACQ580-01 (0.75 to 250 kW, 1.0 to 350 hp) hardware
manual (3AXD50000044862 [English]). For start-up instructions, see chapter
Quick start-up guide
To read a manual, go to
document number.

Obey the safety instructions

WARNING! Obey these instructions. If you ignore them, injury or death, or
damage to the equipment can occur:
• If you are not a qualified electrical professional, do not do electrical installation
work.
• Do not work on the drive, motor cable or motor when main power is applied. If
the drive is already connected to the input power, wait for 5 minutes after
disconnecting the input power.
• Do not work on the control cables when power is applied to the drive or to the
external control circuits.
• Use the lifting eyes of the drive when you lift the drive. Do not tilt the drive. The
drive is heavy and its center of gravity is high. An overturning drive can cause
physical injury.
• Make sure that debris from drilling, cutting and grinding does not enter the drive
when installing.
• Make sure that the floor below the drive and the wall where the drive is installed
are non-flammable.

Check if capacitors need to be reformed

The capacitors must be reformed if the drive has not been powered (either in storage
or unused) for a year or more.
You can determine the manufacturing time from the serial number, which you find on
the type designation label attached to the drive. The serial number is of format
MYYWWRXXXX. YY and WW tell the manufacturing year and week as follows:
YY: 17, 18, 19, ... for 2017, 2018, 2019,
WW: 01, 02, 03, ... for week 1, week 2, week 3,
on page 23.
www.abb.com/drives/documents
EN – R6...R9 Quick installation guide 11
and search for the
...
...
EN –
R0-
R4
R6-
R9
R6-
R9
EN
DE
ES
FR
IT
RU
SV
ZH